Adding control points on sidecut radius to create something similar to magnetraction

[bill622]

Having the hability to break the standard sidecut radius into 2 to 6 sections. Each sections are controlled by two control point where the user can adjust the pullout and the width of effectiveness. The user must have the ability to place them along the sidecut radius.

[splitn2]

Ideas for this.....

1. it works symmetrically on both toe and heel side of course, so you just adjust one side
2. any number between 2 and 6 controller sections
3. sections can be flat or pulled out beyond flat to a defined radius to user spec
4. ideally this is done with graceful curve transitions between sections and main radius sidecut
5. section width between control points is defined by user
6. distance of main sidecut between these sections is defined by user
7. these could also be set asymetrically to suit rider stance eg, for riders with aggressive positive forward angle on both boots heel side could be set back?

thats probably enough for now?