Mike Walters

I tried reproducing this and, while I get the same error when using a rad1o, it doesn't prevent it from running the flowgraph and transmitting correctly. Can you describe a...

The standard HackRF firmware is always in USB mode. Are you asking about switching out of PortaPack mode? If so, this would be a question for whichever PortaPack firmware you're...

It should work OK for wide ranges like that. You may have been running into an issue where a long-running sweep has chunks at plotted at different timestamps, leaving a...

> This is demonstrably not true at least in Linux. When I program it (with the blinky example) via the manufacturer-provided Arduino core, it shows up in the system log...

Closing as I think the question has been covered, but feel free to re-open if you have any more questions!

Can you post a picture of the properties window of the osmocom Source block? I think the issue is that the device properties field is set wrong, it should be...

I couldn't reproduce the issue when running the commands you posted: ``` INFO | __init__ | Building for Cynthion r0.4... Preparing to run yowasp-yosys. This might take a while... Preparing...

There are two ways that error state can come up: * The firmware doesn't match the detected platform. If you flashed either the `jawbreaker` or `rad1o` firmware files to a...

If you're getting that error when building, then you need to install `dfu-util` which includes the `dfu-suffix` program.

I'm going to close this as there hasn't been a response in a while, but feel free to re-open or open a new issue if you still have more questions...