Turtle stuck in idle-lost-halt loop on first setup (possible cause found)

[ANNOProfi]

I have encountered a similar/the same problem as others, namely, that a turtle will be stuck in its first calibration sequence, when it is first connected. However, I have noticed, that this seems to occur, because the "Home" area is not actually, where it should be. My mine entrance is at "26, 171, -16", the map, when prompted to center itself, displays x=104, z=215, which does not seem right. (My world is superflat, but that shouldn't be causing this, right?) I hope this is a lead to fixing this issue.

[ANNOProfi]

UPDATE: I have tested, that this happens, when you run "hub.lua" before editing the entrance position, so a workaround is to first edit the hub_files/config.lua with the correct coordinates and then to launch it.