Max Prokhorov

@adityama Just to verify - does that mean that you have a single relay configured? https://github.com/xoseperez/espurna/blob/55b9f2a52f9fc5a225ae4880d15893d15161209f/code/espurna/sensor.ino#L1473-L1475 (based on this check) @ruimarinho have you tried with recent `dev`? my initial hunch...

@pcornill can you be more specific about the version? which commit is that? does it show values after power-cycling the device?

You will see the 'revision' field on the same page, near the version. Have you tried powering off the device or resetting to factory settings? I mean it. https://gitter.im/tinkerman-cat/espurna?at=5fac3135d37a1a13d69e1993

> OTA and erase_all (I do not have easy access to serial upload) I meant the "factory reset" button, which will remove the active settings. Simply flashing the new OTA...

Just to note, I do happen to have this board with SPI-mode enabled https://www.nxp.com/docs/en/data-sheet/MFRC522.pdf However, not sure which parts of the interface are supposed to be used. Is it collision,...

Nice! Defaults are indeed rough (but it is kind-of possible that the sensor can be pre-configured using PC software tool? since the settings persist based on the .pdf info) I...

If I understand correctly, what you want is to 'hold' the relay while the button is pressed? There is a separate button mode specifically for this, try this out instead:...

> So that is the question, how can I detect button released ? Like I said, just use the switch in the config? Pushbutton in config will cause the 'released'...

Just using a basic wire between GNDGPIO5, I get exactly one 'Click' event per connection / disconnect. Could you check the wiring, perhaps? Another thing to note, we don't actually...

@ksirob35 was the issue resolved via the PR? Regarding Tasmota config, what was it?