Matthias Behr
Matthias Behr
I think the problem is the "aggmode":"max". This does not get ignored! Try to set it to "none".
@hydrocontrol I never tried it / never checked whether letting libsml "device" point simply to an existing (capture) file. You can give it a try but it might fail (due...
@r00t- well, some test would be good :-) should(tm) work :-)
Ich schaue mir den PR mal an. > Am 04.05.2016 um 16:58 schrieb andig [email protected]: > > Ich finde eine Implementierung sinnvoller als einen Cronjob. Zum einen erzeugt cron bei...
Siehe PR #251. > Am 04.05.2016 um 16:58 schrieb andig [email protected]: > > Ich finde eine Implementierung sinnvoller als einen Cronjob. Zum einen erzeugt cron bei jedem Aufruf einen syslog-Eintrag...
Soll ich die Scaler und MeterW1 Änderung von Herrmann als PR vorbereiten? > Am 04.05.2016 um 16:58 schrieb andig [email protected]: > > Ich finde eine Implementierung sinnvoller als einen Cronjob....
Bei schlechter Verkabelung kommt 85 häufiger mal. Ich wäre auch dafür, den Wert auszublenden (dann kann man halt nur bis 84,xx°C messen) > Am 05.05.2016 um 12:32 schrieb Udo [email protected]:...
Da hast du vollkommen recht. Wir sollten den Wert ausblenden und einen Fehlereintrag machen. > Am 05.05.2016 um 13:19 schrieb Udo [email protected]: > > Am 05.05.2016 um 12:39 schrieb Matthias...
@gitka wird das noch benötigt? Dann würde ich das als nächstes hinzufügen.
Which frequency do you have? (how many signals per sec/min?) And what’s your intended „minimum signal high time“ you’d like to ignore? Matthias > Am 08.11.2021 um 21:27 schrieb majowi5...