Max Wilfinger

I like the idea to quickly change the constraints with a right click as in most other CAD software. Cycling with *M* would always mean to cycle through all possible...

@pierreporte https://github.com/FreeCAD/FreeCAD/pull/11884 could help

Now you can also directly right click on geometry to pull up the constraints

I think this could be done. What is the use case where this would be needed? Could you provide a screenshot of an example? What should be selected when the...

@chennes is there already a fix for the unit tests so @ConnorWorrell could mark this as ready for review (if it should be considered for the 1.0 feature freeze)?

The islands are great but mainly for PartDesign features as @abdullahtahiriyo mentioned. I would like to have them as a toggle option on/off. I propose six other ways of indicating...

But a blue colored point would stay blue even when the point is fully constrained? So a open wire / path for surfaces, tool paths,... will always stay blue -...

Not sure if other workbenches can work with the red / white dots (arch/path/draft/curves). Obviously we have a strong focus on the use of sketches in PartDesign.

And points can be used in other WB without problems, there is not only part design. https://github.com/FreeCAD/FreeCAD/issues/12582

There is also a good example from the forum: https://forum.freecad.org/viewtopic.php?p=746322 And it is also not possible to select a vertex which has 3 connected lines (star) and select the right...