Martin Williams

Results 122 comments of Martin Williams

Title: Request to add BMP280 extension to the MakeCode extension gallery

Hi @Tanagogedora, Please see the approval requirements and process here: https://support.microbit.org/support/solutions/articles/19000054952-makecode-extension-and-tutorial-approval

Writing in TS, then checking blocks, then going back to TS breaks formatting and type definitions.

The code at the link above still has the calls to sound.ts. Here's the code without sound.ts https://makecode.microbit.org/_KFs006hsxP46 Load the project. Switch to blocks, then back to Javascript.

Writing in TS, then checking blocks, then going back to TS breaks formatting and type definitions.

`const randDir` becomes `randDir`. Reinserting `const `fixes the errors.

Writing in TS, then checking blocks, then going back to TS breaks formatting and type definitions.

I didn't mean to minimise or forget anything - just figuring out what the error was.

Writing in TS, then checking blocks, then going back to TS breaks formatting and type definitions.

The indentation goes wrong after a section that doesn't translate to blocks.

Extension submission: microbit-drone

@flyshark2024 Please see this article about the approval process. https://support.microbit.org/en/support/solutions/articles/19000054952-makecode-extension-approval

My microbit don’t want to connect with Bluetooth?

Hi @sepp020714-cmyk Please create a support ticket https://support.microbit.org/support/home

Documentation of Compass Heading is not clear

I think it's confusing to use "compass" and "magnetometer" interchangeably. The magnetometer detects magnetic fields, and a compass heading can be calculated from magnetometer measurements of the Earth’s magnetic field....

Add initial test procedures for WebUSB & BLE flashing.

Could both WebUSB and Bluetooth tests 1 and 2 be combined into one test, with test 2 as a last step, as below? I had performed Bluetooth test 1 on...

Add initial test procedures for WebUSB & BLE flashing.

The Bluetooth flashing tests should include pairing with and flashing over a hex built in the MakeCode under test, which I have just done for iOS/Android + V1/V2 with MakeCode...