GarHAge
GarHAge copied to clipboard
marthoc
a Home-Automation-friendly ESP8266-based MQTT Garage Door Controller
You mention "Dual-relay module" in the "Bill of Materials" list, but the link (http://www.robotshop.com/en/2-channel-5v-relay-module.html) is broken. I am a complete electronics noob so I have no idea what is needed...
I already have Z wave sensor mounted on my garage door. If I am not wrong, you are using magnetic sensors to basically broadcast the state of the door. Is...
Mark, I am trying to use this code very simply with a nodemcu and a 4-relay board. I power the relay from a separate 5V line from the same usb...
Small change to make HA see the binary sensor as a garage door as opposed to a generic opening.
Hi, I have your system working on openhab. I was wondering what your thoughts were around not publishing status messages every minute or so. Most of the other openhab implementations...
Update to use latest ArduinoJSON version. (or at least update instructions to specify) Anything after 5.13.2 does not support jsonBuffer and throws errors.
After some days working well now i'm getting issues when the garage doors is closed the homeassistant is getting wrong status inside a minute it open and close again, the...
Will it work with homebridge? I have found a garage door plugin for homebridge and if I'm not wrong then to read MQTT messages there shouldn't be a difference if...
Finally got all this up to replace my old GarageQTPI installation and had spare nodemcu. But having this behaviour which I believe was relateively easy fix on GarageQTPI and setting...
