GarHAge
GarHAge copied to clipboard
marthoc
action triggered on connection to relay
not sure if this is something you can help with, but here goes:
as soon as i connect the relay to the garage door trigger (COM and NO), it triggers an action. at this point, i can control the garage door via MQTT, but the physical button stops working. i am not sure if i'm connecting something wrong, but this happens even if the relay is not corrected to power. and i've tried it with 2 different relays.
help. please.
Strange, normally this would happen if you connect the wires to COM and NC, maybe the relay is broken. Test it with a multimeter, there shouldn't be continuity between COM and NO (when the relay is not powered).
I had this same issue. My relay was active-low (which I didn't realize) and I hadn't set ACTIVE_HIGH_RELAY to false. I updated the .h, uploaded the new sketch and it worked perfectly (physical buttons work again).
I had this same issue. My relay was active-low (which I didn't realize) and I hadn't set ACTIVE_HIGH_RELAY to false. I updated the .h, uploaded the new sketch and it worked perfectly (physical buttons work again).
That just saved my day. I was in the same case using an ESP-01/01S And here is how to set ACTIVE_HIGH_RELAY to false in ESPHome: https://esphome.io/components/switch/gpio.html#active-low-switch
Thank you!
