marshr32

OK I'm getting somewhere, but there is some weird stuff is going on here. With Feed Hold and Reset (E Stop) pins grounded, and cycle start open, if I set...

>An error generated by UGS? When I said error, I should have put alarm. But this alarm is constant, not like it's only looking at a state change.  >...

This is in /grbl/config.h as cloned >// After homing, Grbl will set by default the entire machine space into negative space, as is typical >// for professional CNC machines, regardless...

> I have to check what the ESP32 is outputting to make ioSender crash - the meditating guru present in this chip can drive one crazy with all its antics......

It looks like my espduino is just sending back a heap of rubbish on the comms and overwhelming the sender. I tried to switch to check mode in ugs and...

Ok, trying this again and still no real luck. IOsender 2.0.40 will start up with no problems now but it's very finnicky about inputs. Is it possible to make it...