Mark Walker

To figure this out, I think I'll need a serial log (it's off by default, you turn it on in Octoprint settings). Or at least copy and paste the relevant...

Ah. You have "Replicator 2" set as your printer type in GPX settings perhaps? You should set it to "Replicator 1 Dual" . A rep2 doesn't have a heated platform...

Volumetric won't work very well unless you also fake some volume to linear translation by setting nominal and actual to do the multiplication for you.

Typically it is because the printer type setting has been reset to Replicator 2. This can happen if the gpx.ini gets corrupted or deleted. There was an instance a few...

Typically it is because the printer type setting has been reset to Replicator 2. This can happen if the gpx.ini gets corrupted or deleted. There was an instance a few...

Typically it is because the printer type setting has been reset to Replicator 2. This can happen if the gpx.ini gets corrupted or deleted. There was an instance a few...

Well, kind of. I've made significant changes to the cancel code in every release and there are some pending. However, it's possible that the issue you are hitting isn't really...

But that's because you didn't turn off the printer and then wait for OctoPrint to show disconnected and then turn it back on and hit reconnect. It's not the upload...

It will still show red because that just means the last attempt to print it failed. It'll still print (as long as you clear the state I mentioned).

And in the version you have, it should be sufficient to click the disconnect button and then when that succeeds click the connect button. The only time you should have...