Print progress bar completes in matter of minutes for 5 hour print while printer doesn't even move.

[Burritobun]

Using the GPX plugin (duh) and set it to Replicator 1 since the Qidi dual 2018 is very close to it. Printer is running sailfish 7.8. Using Slic3r to slice (reprap gcode output). After the heaters get to temp, the screen on the printer will flash from the heating page to the printing page, and every time it flashes back from one another, the progress bar goes up by 10-15% on the printer LCD and octoprint. The actual printer does nothing besides sit there and maintain temps.

[markwal]

Perhaps you could put the gcode that is causing you problems somewhere (Dropbox?) and post a link here.