BLTOUCH_SET_5V_MODE is not compatible with the Z_MIN Creality CR10 Marlin-2.0.x

Open Ground-Source opened this issue 4 years ago • 1 comments

Hello, I am struggling to get firmware that will operate my Creality CR10. I have upgraded the motherboard to 4.2.2 with BLtouch When I try to compile the firmware i get the sanity check fault: #error "BLTOUCH_SET_5V_MODE is not compatible with the Z_MIN_PIN."

I have used Marlin-2.0.x and the configuration for Creality CR10 V2 with Visual Studio Code I am not experienced with this. Is there any who can help?

Oct 13 '21 21:10 Ground-Source

the 4.2.2 is not pandapi board. you no need to enable the BLTOUCH_SET_5V_MODE in the configure_adv.h since the MCU on the 4.2.2 is stm32 which run at 3.3v voltage niujl123 @.*** Signature is customized by Netease Mail Master On 10/14/2021 05:15, Ground-Source wrote: Hello, I am struggling to get firmware that will operate my Creality CR10. I have upgraded the motherboard to 4.2.2 with BLtouch When I try to compile the firmware i get the sanity check fault: #error "BLTOUCH_SET_5V_MODE is not compatible with the Z_MIN_PIN." I have used Marlin-2.0.x and the configuration for Creality CR10 V2 with Visual Studio Code I am not experienced with this. Is there any who can help? — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub, or unsubscribe. Triage notifications on the go with GitHub Mobile for iOS or Android.

Oct 14 '21 00:10 markniu