Closed Loop Motor Support.

Open designerwebhosting opened this issue 5 years ago • 2 comments

Does the Pandapi Hat support Closed Loop Motors? Or is it just updating the Marlin config to use them? Thank you.

May 29 '20 12:05 designerwebhosting

Hi, just like other 3D printer control board, only support step motor driver TMC2209/2208/ A4988 ..., not support closed loop motor. it based on the marlin,so the configuration is the same.

May 29 '20 15:05 markniu

As far i know do you use closed loop driver just as A4988. You don't have to change anything in firmware. 1/16 micro stepping and you are good to go

May 29 '20 21:05 Moorviper