openexposer

openexposer copied to clipboard

@mariolukas Is this project maintained or expected to be picked back up? If not, was there some particular technical issue that stopped it being taken further? Thanks.

jtmorris245

Where can I see the laser driver circuit and the connection to Arduino?

dementiev-net

Use bounding volume hierarchy to speed up slicer

4

The slicing algorithm does a bad job at the moment when intersecting the rays with the mesh triangles. This could be dramatically improved by using something like a bounding volume...

cemonds

Replace resistors for IC-HK/B laser driver ic. enable -> 10 ohm standby -> 120 ohm

mariolukas

add traces to nanites i2c or serial bus

2

mariolukas

As an enhancement for laser safety it should be possible to cut off the supply voltage of the laser driver via a micro switch integrated into the case. The easiest...

cemonds

add additional pins to flatband connector

1

for more polygon mirror support add additional pins to the flatband connector. some GND and VCC pins are redundant

mariolukas

add level shifter for nanite i2c communication

1

mariolukas

- as mounting option for the nanite (which does all the fancy PWM stuff)

mariolukas

mariolukas