Picoclick-C3
Picoclick-C3 copied to clipboard
makermoekoe
So...I bought 3 pcs a couple of months ago...and I managed to brick 2 of them trying to flash ESPHome onto them. After flashing serial log (Termite) shows : ```...
The part named F2 in schematic and BOM has a value of 0. What would be the correct value here? (also: since I can‘t find any info on this anywhere,...
How come the low discharge rate of such a small battery doesn't cause a brownout when it draws 200+ mA at boot?
In the README it says that most standby current is used by the voltage divider connected to the battery which according to the schematics is connected only to the ESP32....
I just finished watched the YouTube video and came to check for the schematics. However they do not seem to be pushed yet. Can you tell when we can expect...
Hi, thanks for sharing this great project. Some sources recommend quit large capacitors (>1000uF) for applications with WiFi & BLE in order to prevent "random" reboots and similar errors. Have...
Hi, according to the schematic the BUTTON line could get ~3.8V when pressing the on board button, which would be more than the Max Input Voltage specified for the ESP32...
I cannot find a proper antenna or any matching circuit in the schematics and/or picture at all so was wondering how good the range on these devices will be (both...
Hello, I've built an similar picoclick based on yours. I want to flash some Arduino Sketch over the native USB (gpio 18/19). Flashing with an external USB/Serial converter works great,...
If i would add a second button, would this be correct: 
