SBASE V1.3 & TFT35 disconnect always

[beatkipfer]

preconditions_ Controller: MKS TFT35-FW / Firmware smmoothieware-cnc.bin Display: MKS Base V1.3 Board Firmware MKS_TFT35_laser_V1.0.3 Connections: No connections to USB or COM Baudrate: tried all wirering: nearly nothing only X & Y steppers 24V Power and the cable between controllerboard and TFT

The problem is, that the controller board and the display don't communicate stable. The display switches between connected and *disconnected" allways and therefore there is no chance to send a file from the displays SDcard to the board. even more problematic nearly no command sent by the display reaches the controller board.

please support me to solve this problem, like this I can't use this configuration and have to go for different harddware.

[sivaelid]

Hi See #512 and associated responses . The software is Rubbish and MKS are not good at fixing problems. The best solution is to disable the Alarm function in the GRBL software but then its less safe the other option is to set up addition buttons as in the response from to #512 by francois14-decroix. I hope this helps

BR Simon

[nfroadin]

Hi, the solution is changing the baud rate in mks_config.txt file

#baud rate (9600:1; 57600:2; 115200:3; 250000:4)

cfg_baud_rate:4

Change the baud rate to 115200

cfg_baud_rate:3