MKS-TFT
MKS-TFT copied to clipboard
makerbase-mks
Blower Fan to 100% with AUX1 display connected
Hello, i installed a TFT35 with WIFI to my MKS GEN L V.10 board via AUX-1 port. There are some issue with the fan. When the display is connected to the board and i switch on the printer, the blower fan starts blowing at 100%. If i go to settings, fan, i see that the fan is off for the firmware and also for the display. If i tap on 0% or on 100% or other button in fan setting the display become total WHITE and i can't use it unless i detach the plug or i switch off the printer. I tried also to change the speed with the stock display RepRap but the TFT turns white anyway. If i don't connect the TFT35 all works fine and the blower fan is off on startup.
Please help me!
Regards
If you only use MKS TFT35 and it's will work?
With only MKS TFT35 NOT work!!! With only reprap works perfectly... With rep rap + TFT35 the blower is on but on the two displays the blower seams off (0). If I try to change that value to 255 or to another value ... the firmware crash and also the display become all white!!! Any help?
Is MKS TFT35 the latest firmware? Can you provide vodies when you use MKS TFT35 connect MKS Gen_L V1.0?
Here the video
https://user-images.githubusercontent.com/25211647/103130320-7cf1dc80-469c-11eb-9fca-4cfbc6940a57.MOV
as you can see in the video if I try to stop or start the blower it is continue to blow at 100%. When I use + o - the firmware crash and the display become white
Which interface are you FAN connecting?
To the right pins of the blower so D9 pins
Is FAN turned on by default when it is powered on?
Yes but it is a news ... some weeks ago was not! When I power up the printer ... the fan must be off!
But this is the opposite of most users.
When start a print the blower must be OFF for first layers. If I put a Gcode the switch off the blower, this blower continue to blow at 80%... this is not standard. Now I tried to change board, to a new mks gen l v2.1. I hope this helps.