unable to activate CAN0 native CANBUS

[DK4YA]

To use a toolboard (ebb36) I couldn't query can0. The following status messages are displayed by the system:

here the configfile "can0 "@/etc/network/interfaces.d/:

The systemimage is the latest downloaded from MKS googledrive with Armbian 22.05.0 Does anyebody got the same problem?

[derTimm0]

i "belive" the connection via cunbus works but iam get no connection to the mcu part :-/ how i set the serial(?) conection to the skipr on printer.cfg. if i try to get the mcu id it will nothing show on USB/uart (via kiauh)

[rt1970]

i have also no such device. My board is MKS THR42. If i try create Firmware it will create a .bin file. But THR42 will .uf2 file. I have flash klipper.uf2 from THR firmware (can) by press "Boot" Button, then i plug USB in my PC and i copy the File to the new device with 128MB size. It closed the explorer. Now i dont have a serial port. That should be fine... what klipper.bin config should i use on SKIPR?

[rwetzel67]

Any answer on this? Same here: creating the file /etc/network/interfaces.d/can0 does nothing... can0 is not available. Anything else that whould be done??