MKS-Robin icon indicating copy to clipboard operation
MKS-Robin copied to clipboard

Published 20 hours ago • verified publisher icon makerbase-mks

Input and output voltage issue

Open Drakstein opened this issue 5 years ago • 2 comments

I have a simple question about the voltage of the MKS ROBIN v2.4 board, it suports input 24V, but it also outputs 24V to the motors??? By the way, I will use a BL touch, anyone here already used it, any suggestions? I will use in a core XY model.

Drakstein avatar Nov 22 '19 02:11 Drakstein

On the MKS Robin motherboard, the motor drive voltage depends on your power input voltage.

makerbase-mks avatar Nov 25 '19 10:11 makerbase-mks

@Drakstein The voltage to the stepper motors doesn't seem to really matter because your stepper drivers will only send the set/adjusted current to them. I run my board on 24volts with a corexy setup using 12volt motors (I think), but I set the current (plus a little bit) to the point where there wasn't missed steps and everything works great.

mattdog01 avatar Dec 30 '19 19:12 mattdog01