MKS-Robin-Nano-V3.X icon indicating copy to clipboard operation
MKS-Robin-Nano-V3.X copied to clipboard

Published 20 hours ago • verified publisher icon makerbase-mks

Printer stops while printing

Open seymon92 opened this issue 3 years ago • 4 comments

I have problem with random stopping when printing, I use TM2208 (standaolne) stepper drivers with fan cooling and Mks-Robin-Nano-Marlin2.0-Firmware. It stops in a different layer and different spot.

Where could the problem be? Thank You

seymon92 avatar May 24 '21 12:05 seymon92

Hi! Can you make sure that the temperature of the heating head is constant? I guess it is caused by the fluctuation of the heating head temperature.

mks-viva avatar May 28 '21 08:05 mks-viva

Hi, Thank You for reply. I dont think there is problem with head or bed temperature. If I do auto calibration, my printer disconnect and I cant see any information in Pronterface (but calibration continues).

I tried to print with cold head (without filament) with same result.

seymon92 avatar Jun 01 '21 11:06 seymon92

You use USB connect to PC printing?

mks-viva avatar Jun 02 '21 02:06 mks-viva

Yes, I have not luck with this board, I cant connect RepRapDiscount Smart Controller with my board. I enable controller in Marlin and invert EXP connectors (previously I used SKR boards), but display only lights up, but shows no informations. So I print from computer.

seymon92 avatar Jun 02 '21 04:06 seymon92