Problems with the MKS 3D TOUCH, add the offset.

[pistachin2]

Hello, I have the original MKS 3DTOUCH mounted, and its operation is correct. The problem comes when the second and subsequent autolevels are performed. The offset of Z is added, that is, each time an autolevel is carried out it adds the deviation, and when printing the nozzle it is separated more and more from the bed. The first impression (just calibrated according to the MKS video) is perfect, the second the filament barely reaches the bed, and the third and successive you can imagine, a ball of filament. At the start GCODE I have to perform a G28 and G29, and it happens with firmware 2.0.3.2, 2.0.3.3 and 2.0.3.4. With later fimrwares I have not tried. My board is a v1.2 Thank you very much.

[hbismis]

hi, i have a same problem my nano v1.2 motherboard z offset is always chancing when print restart or resume. i connet the sensor for auto leveling and is working but when is start to pirint there is a 5-6 mm diffirenc and if i set zoffset -5-6 mm, than 3-4mm more this time can u help me