MKS-Robin-E3-E3D

MKS-Robin-E3-E3D copied to clipboard

-

flywork39

I use Klipper firmware with the Robin e3d board. Sadly i broke my USB port on the board. Can I connect it to my raspberry pi via some pins on...

kjanek

Extruder not working when MKS 12864 Mini V3 enabled

12

I recently upgraded my board to a MKS Robin E3D V1.1 and had everything working fine with the factory Anet LCD Screen running Marlin bugfix_2.0.x. I decided to upgrade the...

bschenke2

Hi all, Can anyone change the device name that apears on Device Manager? I want to use these boards for selling printers and would like to apear the name of...

Medina-ui

Cooling Fan 100% all the time

5

The cooling fan shorted out on my E3D v1.1 most probably the cooling fan MOSFET most probably dead caus it's working all the time at 100%. Can I change it...

kjanek

Hi! As the dumb I am I've shorted J5 with a dead fan (was in my parts bin instead of the recycling bin) and my board is no longer working....

pFallenAngelq

PWC issue

28

hi , i,m trying to use a pwc board on my robin E3D with tft 35but i;ve got some troubles.... when i enter the code #if ENABLED(PSU_CONTROL) #ifndef PS_ON_PIN #define...

ptitpuma

Heatbed FET overheats! - PCB design error - Output FETs GATE voltage only getting 3V3.

2

According to the SCH the CPU is powered with 3.3V This means that the FET GATE that drives the heat bed can get a maximum of 3V3. Accorder to the...

JazzinSA

Сompiling the firmware Marlin 2.0.9.3 in VScode

2

I compelled the firmware on MKS Robin E3D v1.1 in VScode. I have this error, idk what to do with this. Verbose mode can be enabled via `-v, --verbose` option...

happy-zelebob

Hi! I ran into a problem setting up Marlin 2.0bugfix for this board. It lies in the fact that when printing is started from the SD Card, the extruder does...

Djentonic