MKS-Monster8

MKS-Monster8 copied to clipboard

Hi guys, I installed Phaetus Rapido hotend on my Monster 8 board but i cannot make it heat it up properly, looks like HE0 is just 12V. how can i...

canadank0

I can not find info for max amps on the 5v rail. I tried to run a cm4 off the pi port but kept getting under voltage so I assume...

TheSin-

Bootloader without beep

1

Hey! Would it be possible to get a bootloader that doesn't trigger the beeper, similar to the one that exists for the [MKS-Robin](https://github.com/makerbase-mks/MKS-Robin-E3-E3D/issues/35)?

30350n

USART in MKSPI

1

Hello, forgive me my English. I recently purchased an MKSpi, and I would like to communicate with the Monster8 using the USART, has anyone tried this, and was it successful?...

leorpereira87

Monster8 v2 H43 Wifi

1

Hello, how can I connect the mks H43 screen and the MKS Robin wifi module and make it work. If I connect the screen to uarts 1 and the wifi...

rai0012

Hi, I believe that PB11 is missing off the schematic diagram for U1, and that it should be connected to the wire labelled SPI1_DET. Thanks :o)

HattonLe

Monster 8 USB/sd card not working in firmware(I can fash firmware still via ethier) . This must be a setting in Marlin but I can't figure out which one it...

Dawaitizova

fix multiple `SAVE_CONFIG` section. These configuration files contain more than one `SAVE_CONFIG` section File Change: `MKS-Monster8\klipper firmware\Voron 2.4 config\printer_v1.cfg` `MKS-Monster8\klipper firmware\Voron 2.4 config\printer_v2.cfg`

Neko-vecter

Hello, i want to use roborock fan as part fan. it requires PWM pin and i couldn't see which pin i can use. The project link is belove. Thanks. https://github.com/condottab/Roborock-CPAP

selimayaz

Monster8 v2.0 Neopixel pin(PC5) not working

2

Hi Voron的Stealthburner, 使用三顆連接的SK6812, 不點亮 已進行過的排查: 1. 同一串LED接到Arduino測試, 卻可以點亮, 並可依指令變色. 2. 在Stealthburner的空中接頭處使用電表測量, +5v, 且正負極的接線無誤 3. 在靠近主板的data線, 接上100歐姆電阻, 仍不點亮 4. Mainsail控制介面中, 有列出兩個neopixel, 分別是min12864與sb_leds(表示config有被讀入), 前者可點選顏色變色, 後者卻無反應. 5. 確認config中, pin: PC5, 符合官方PIN diagram對此pin的編號. color_order則是RGBW與GRBW都試過了仍無效...

ivantem86