MKS-Monster8

MKS-Monster8 copied to clipboard

Mks Monster8 board firmware flash problem

21

Hello, I just received my monster8 board that I purchased from Aliexpress store. I have been trying to flash the firmware for the klipper for 2 hours but the board...

turnali

外接驱动时，跳帽设置

2

1. 当外接驱动时（如雷赛 m542 驱动），跳帽是否是按 A4988 设置？ 2. 雷赛 m542 本身可以设置细分，怪兽主板上的细分设置是否还起作用？ 

leon-titan

Here is protection for the hotbed temp  if for some reason, the 24v going to pin 1 of j26, then every circuit is protected by the zenner D46-1, it...

tungbuivn

Using a Mac running Monterey. I've never worked with a stm32 board before but have had experience with Arduino boards. I am wanting to use this board because it has...

TrulyMarcus

USART 3 on MKS MONSTER 8 V2

11

Hi, I would like to have confirmation on the rt and tx usart3 pins. RX = PD8 and TX = PD9.  Thank you for your confirmation.

LoloMake60

CANbus usage ...

2

It is possible to connect a expansion board like FLY SHT36 board in the Monster8 CANbus port and control this expansion board? If possible, Can you give a few instructions...

themacboy

USB to CAN bus bridge

2

I flashed the firmware after build ,but cannot find this board both of windows and linux 

tungyao

File step for Monster 8 v2?

2

Hi, Can you publish the file step for monster 8 v2? For 3D integration. Thank you.

LoloMake60

Configuration for use MKS H43 on board Monster 8 V1

2

Hello to all I bought a mks-monster8 version one board and a mks-h43 Display some time ago Unfortunately, I did all kinds of configuration on the files so that they...

satinfo50

Configuration for use MKS H43 on board Monster 8 V2

3

Hi, I would like to connect my MKS H43 screen to the monster 8 V2. What is the configuration to use USART1? For Marlin firmware. Thank you

LoloMake60