Schematic ou gerber file

[greentocic999]

Hi Everyone, i need to get a schematic ou gerber file of the mks-dlc32 V1.1 (LS ESP32 PRO V1.1). Grateful

[killthekid]

@greentocic999 - did you have success for the file? Currently i'm looking for a shematic of the PCB. Do you have any documents?

[greentocic999]

I was unsuccessful, in fact. But what is your question, I can try to help you

---

De: Alex @.> Enviado: quinta-feira, 11 de abril de 2024 16:04 Para: makerbase-mks/MKS-DLC32 @.> Cc: greentocic999 @.>; Mention @.> Assunto: Re: [makerbase-mks/MKS-DLC32] Schematic ou gerber file (Issue #469)

@greentocic999https://github.com/greentocic999 - did you have success for the file? Currently i'm looking for a shematic of the PCB. Do you have any documents?

— Reply to this email directly, view it on GitHubhttps://github.com/makerbase-mks/MKS-DLC32/issues/469#issuecomment-2050333067, or unsubscribehttps://github.com/notifications/unsubscribe-auth/AVUXCYX6H7X44GH5QY5PGATY43NC5AVCNFSM6AAAAABFQQRKL2VHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDANJQGMZTGMBWG4. You are receiving this because you were mentioned.Message ID: @.***>

[killthekid]

I try to install a Limit switch for Z, as the pcb has a connector for it. On the custom configuration in fluidnc i can select a (gpio) port, which the limit switch is connected to. I don't know which port to chose... Also tried to measure/trace the signal pin on the pcb to the esp, without success.

[greentocic999]

What's the version of your pcb?

[killthekid]

It's LS ESP32 V1.0 i thing about going on a MKS LS ESP32 PRO, any recommendations?