Change fixed point of G-Code Viewer rotation

[seark]

Requested feature:

Change fixed point of rotation from camera to bed center to match behaviour of slicers and cad programs.

Solves the following problem:

No response

Additional information:

No response

[dw-0]

to match behaviour of slicers

Afaik there is no uniform behavior of slicers in that regard.

[Sindarius]

This is likely because the bed size was not initially loaded so it is focused on 0,0 if you hit the camera reset button it should focus on the center of the bed. I'll see about automating that in a future release when the ui changes the bed size