madmacks59

Is this getting any attention?

I am having the same issue. And the Arduino board manager process fails as well.

Is this getting any attention?

Same issue, neither the http or https urls load.

If you're not using pull-up resisters and you didn't define them with something like this "pinMode(S1, INPUT_PULLUP);" then the pins could be floating and you'll get random HIGH or LOW...

The specification states that device ID number "identifier" for accessories must be a unique random number generated whenever a factory reset happens (meaning when you build your code and deploy...

> Maybe a bit late, but I noticed your "password" was "222-22-222", which is explicitly called out in the HAP docs as not allowed. That could be your problem. Where...

Search for a project named "4 Relay & Switch" by Sachin Soni (aka techiesms). He has several projects that use physical switches and relays and I've got it working fine...

As far as I can tell this is caused by the code update identified in the change log as "Add on_pre_connect() callback". I went into the change log and compare...

I was finally able to ssh and when i run lsblk I get the following.... ` umbrel@umbrel:~$ lsblk NAME MAJ:MIN RM SIZE RO TYPE MOUNTPOINTS mmcblk0 179:0 0 59.5G 0...