macdroid53

Random comments: - The macro is a workaround - The LCS (not just the normal) should be shown during creation of both sketches and Datum planes - The LCS (not...

Most of the time the x/y aren't needed. But, there are occasions where it is quite helpful. For example, when using MapMode dialog to arrange the location of a sketch,...

> If possible, this could be added to sketch planes as well. There only x, y is Überresten (it h, v as it is called in sketcher) [#11781 (comment)](https://github.com/FreeCAD/FreeCAD/issues/11781#issuecomment-1868249260) My...

Seeing the orientation of the X/Y axis is why sooooo many people find Map mode absolutely frustrating to use. Have a look at these tutorials, when using any of the...

It should be available, via toggle, for any entity where it might be useful; sketch, datum, face. (possibly a right click) It should be presented when creating a new sketch...

A Datum can be attached/mapped with all the same modes as a sketch. So, being able to see which way all axes points, can be of interest.

Advance use of Datum planes can be as advanced as sketch placement. If you are locating the DP on some off angle face, then it is important to know which...

I don't feel strongly for or against. If the text can be done unobtrusively, but red/green/blue is good enough for me. They indicate the positive direction of each axis. But,...

That is a very good point. Both DP and Sketches can be rotated. The axis cross would make this clear.

Consistency throughout FreeCAD is a good thing.