mac651955

Xfuzz, I have been doing a email collaboration with Blondihacks so if you could forward your email to me I could just forward all of the emails I sent to...

Don’t want to load GitHub down with all those emails.

DS, I didn’t adjust anything on feed rates. I concentrated on getting the servo to turn exactly 3 times to one rev of the spindle when the ELS was set...

DS, What feed rate did you have set on the ELS when you did your measurements? You also are assuming incorrectly that I know anything about coding. LOL. I too...

DS, Did you hit the speed limit at a lower RPM? Sent from my iPad > On Mar 17, 2021, at 06:10, dsgroninger ***@***.***> wrote: > >  > My...

Xfuzz, The changes to the servo driver remain the same. James posted his settings in my other thread about servo not slowing with lathe. Match his settings with the exception...

That is correct. Sent from my iPad > On Mar 18, 2021, at 20:10, xfuzz ***@***.***> wrote: > >  > Oh I forgot, one more thing .where do I...

No wait on that response. Sent from my iPad > On Mar 18, 2021, at 20:10, xfuzz ***@***.***> wrote: > >  > Oh I forgot, one more thing .where...

Xfuzz, had to look at code on my computer to make sure: change // #define INVERT_DIRECTION_PIN true To #define INVERT_DIRECTION_PIN true

DS, Great write up and pics to clarify any areas of concern. Although I chose to eliminate the change gears your implementation works as well. One thing I did notice...