sdebug

sdebug copied to clipboard

20220117 很抱歉，因为个人原因，已不在维护，可以使用 https://github.com/swoole/yasd

进度

• 基于 xdebug2.7(https://github.com/xdebug/xdebug), 目前修改基本完毕了

注意事项

• 为了避免 swoole 的检测 xdebug 警告, 扩展注册的名称是 sdebug, 如果想使用 Phpunit CodeCoverage , 需要手动把检测 xdebug 的判断修改成 sdebug
• 单步调试: 如果php不是7.3的, 建议使用 sdebug_2_6(https://github.com/mabu233/sdebug/tree/sdebug), sdebug_2_7 可能需要与phpstorm2019搭配使用

Clone

You can clone the Sdebug source directory with::

git clone https://github.com/mabu233/sdebug.git

Then move into this new directory::

cd sdebug

Compile

If PHP is installed in a normal, and uncomplicated way, with default locations and configuration, all you will need to do is to run the following script::

./rebuild.sh

This will run phpize, ./configure, make clean, make and make install.

The long winded way of installation is:

#. Run phpize: phpize (or /path/to/phpize if phpize is not in your path).

#. ./configure --enable-xdebug (or: ../configure --enable-xdebug --with-php-config=/path/to/php-config if php-config is not in your path)

#. Run: make clean

#. Run: make

#. Run: make install

#. Add the following line to php.ini (which you can find by running php --ini, or look at phpinfo() output): zend_extension="xdebug.so".

Please note, that sometimes the php.ini file is different for the command line and for your web server. Make sure you pick the right one.

#. Unless you exclusively use the command line with PHP, restart your webserver.

#. Write a PHP page that calls phpinfo();. Load it in a browser and look for the info on the Xdebug module. If you see it, you have been successful! Alternatively, you can run php -v on the command line to see that Xdebug is loaded::

$ php -v
PHP 7.2.0RC6 (cli) (built: Nov 23 2017 10:30:56) ( NTS DEBUG )
Copyright (c) 1997-2017 The PHP Group
Zend Engine v3.2.0-dev, Copyright (c) 1998-2017 Zend Technologies
	with Sdebug v2.x.x-dev, Copyright (c) 2002-2017, by Derick Rethans