lyncker

After reboot EdgeTPU not found

1

After reboot the viseron container starts automaticly, but in this case always the EdgeTPU is not found: [ERROR ] [viseron.detector.edgetpu] - EdgeTPU not found. Detection will run on CPU If...

After a while viseron gives an errror : [rtsp @ 0x21d1710] RTP: PT=60: bad cseq 5c4c expected=05b4

3

After starting viseron everything seems to be ok at first, but after a while it gives this error every 10 ms : [2021-09-14 08:25:51] [ERROR ] [viseron.camera.stream_segments.mycam] - [rtsp @...

Foscam stream leads to errors

1

I tried to connect my Foscam to Viseron using the RTSP stream , but with this cam I get errors: `[2021-07-14 17:59:56] [ERROR ] [viseron.watchdog.subprocess_watchdog] - Process terrasse_vorne_segments has exited,...

After recording an python error is reported

2

I am running Viseron on a Rasp3 with a Coral Stick added.... I configured the recorder and MQTT. After an dection event occured i get the following error in the...

Viseron is bombing MQTT Messages in a loop

8

Hi , I am running Viseron with 3 cams sending MQTT messages to my broker service. I noticed that sometimes , if someone was doing something in front of the...

Example LoRaWan_OnBoardGPS_Air530.ino stops working with HTTC-AB02S after hours

4

Hi, im trying to run the example (LoRaWan_OnBoardGPS_Air530.ino) from this repo with my GPS CubCell Board HTTC-AB02S. After some hours (usually more then 12) the board stops working, which means...

tuya_system: set tuya_system start_scan not available

1

Hi , I just installed fhempy and the tuya_system but thie command for scanning the devices as described in the docs is not available. For me it seems that the...