Andrew Scheller

The RUN connector is in different places on different models of Raspberry Pi, whereas the HAT and uHAT specs are universal across all models of Raspberry Pi. (AFAIK it's perfectly...

> If it is worthwhile to recommend "BOARD MUST MAKE SURE PoE HEADER DOES NOT FOUL" on the uHat spec then it is worthwhile to say the same on the...

Possibly this is a combination of #149 and https://github.com/raspberrypi/noobs/issues/168#issuecomment-32205403 ? I'm planning to try and sort out all these issues before the release of NOOBS 1.4 :-)

You still need to rebase this onto the latest version of `develop`.

Yep, "Files changed" tab at the top shows only 2 files :slightly_smiling_face:

Does https://www.raspberrypi.org/documentation/configuration/uart.md help? Although obviously there'll be some differences between the "full Linux" of Raspbian and the "cutdown Linux" buildroot used by NOOBS.

I dunno if it was a typo in your earlier comment, but IIRC the `dtoverlay` stuff needs to to go in `config.txt` rather than `recovery.cmdline`? And in Raspbian there's `dev/serial0`...

`/dev/tty50` - LOL, did you mean `/dev/ttyS0` :wink:

If only you had a UART connection that you could copy'n'paste from... :rofl:

ping @liamfraser