Repetier-Firmware-4-Davinci

Repetier-Firmware-4-Davinci copied to clipboard

[FR]Add platformIO support

8

I will add platformIO support - it should allow to patch the due source automaticaly and so no need to do any manual changes also it should allow to not...

luc-github

inactive time should be used during filament changes

23

if the printer runs out of filament it should cool down using inactive time in eeprom. mine stayed on the filament load screen at full temperature for over 10 min.

netpipe

Resume printer after M600

9

Hi , i have some troubles with filament change during printing . When i put M600 , printer is going to load / unload filament well . But it makes...

patator03

Disable Door sensor when using Unload / Load

3

as Door need to be open and sensor beep when heating which slow down the process and is anoying

luc-github

Typo mistake Extruder 1/2 instead of left / right

1

some update have been lost when merging the 0.92.10 need review / reapplied the changes

luc-github

Filament printed value is reduced on every power cycle

34

Running from commit a1d781657069af6c0a652bb01f8aebbff0a004cb, the 'Filament printed' value consistently drops every time the power is turned off, and later turned back on. This isn't mid-print power cycling, it's completely done...

cdoc83

How to add 2nd fan to DaVinci 1.0a

3

Hi guys, I know this is an old printer, but after flashing repetier on my 1.0a I've printed tpu, pla, petg and prints very well, I want to add a...

skinnyguyfpv

[Question] Cords show up as NAN

1

I finally got repetier to flash to my da vinci 1.0a and when I try to home my axis it just says "NAN" for all of them. I don't know...

beepboop234

After uploading "usb device not recognized" constantly reconnecting printer still displaying 2 black bars

6

What is your question ?

Kitzakip

I think my printer isn't being detected? da vinci 1.0

8

went through all the steps, trying to now press on upload on the Arduino, got this error.. anyone know why? 

kalitakomwa