Tom
Tom
ok, so how can i dump it? I'll connect cloud adapter then directly to additional PCB.
Thanks, will do tomorrow.
> Yes connect, and on different socket connect heishamon in listen mode, also enable hex dump and wait for telemetry @geduxas What do you mean on different socket? I have...
Sorry @geduxas But then i need a cn-mode cable, or? The 2 cables i have i can only connect to cn-cnt which is bigger than cn-mode.
@geduxas Here the startup log from additional PCB in listen only mode: ``` Sat Oct 25 16:28:13 2025 (15002): Starting initial wifi scan ... Sat Oct 25 16:28:13 2025 (15019):...
K-Series, i'll check energy when pump is running. A little bit complicated as i have some automations running in Home Assistant and Heishamon.
It was only connected for startup (both on expansion board). Then connected back on mainboard with proxy as i need it working with writing. But will do again a check.
@geduxas Here from startup, then additional PCB activated in Pana and then start the pump. I don't know if i get all values in Cloud. But in Heishamon at least...
I don't know if the taw adapter gets TOP15 and TOP16 as this is also not stored in the Service Cloud of Panasonic.
I see this always (at 17:00 it was connected to extended board). But where should i see TOP15/16 or calculated COP in the Service Cloud? :