grbl_stm32
grbl_stm32 copied to clipboard
langwadt
grbl for stm32 with nucleo stepper drivers
Hi again, I hope you are doing well. Are you able to suggest a way to free this project from using eclipse ? Every time I update the eclipse package...
Hi, I notice in the code you put a "hack" in to allow a slow start of your spindle controller. I have a chinese VFD with PID controlled spin up...
Hi, I want set up an opto isolated 10V control signal for my chinese VFD for the spindle. Having set up the opto I went to test and found I...
Hi, I've been debugging using your code on IHMO3A1. I wondered why you set TIM2 running straight away and then used a global to keep track of whether GRBL needs...
I'm trying to find out why the lower priority serial link is distrupting the stepper motor pulses. As a result I have been examining exactly how the interrupts have been...
Is there any chance that you will update to grbl 1.1? That way i can use laserweb3, with my plasma cutter...
Hello, I'm just starting off making a router/cnc and have some Nucleo401re boards lying around . Can I compile your source code with the online compiler for mbed and are...
What other STM32 expansion boards than the IHM01A1 can I use with this code? If that's the only board supported right now, how hard would it be to add support...
i am trying to compile your code in keil mdk uVision 5 but have no success yet can you plz help me out hoe to solve this issue i got...
One of my main reasons for wanting to get off AVR was serial interrupt priority being non modifiable and fixed at a level higher than the stepper interrupts. This means...