Rectangles are not rotated

[Squonk42]

I had an issue with a rectangle in tDocu layer (51) that I used to represent an LQFP pin: the original rectangle was 1 mm x 0.22mm and laid out 2x16 of them to make the left and right LQFP sides, but I rotated them 270° to make the top and bottom sides.

Unfortunately, the rotated rectangles are not rotated by the conversion.

[lachlanA]

Can you send me the files ?

So I can have a look at the problem

Lachlan

On Tue, Nov 28, 2017 at 8:29 AM, Michel Stempin [email protected] wrote:

I had an issue with a rectangle in tDocu layer (51) that I used to represent an LQFP pin: the original rectangle was 1 mm x 0.22mm and liad out 2x16 of them to make the left and right LQFP sides, but I rotated them 270° to make the top and bottom side.

Unfortunately, the rotated rectangles are not rotated by the conversion.

— You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub https://github.com/lachlanA/eagle-to-kicad/issues/26, or mute the thread https://github.com/notifications/unsubscribe-auth/AHdMe9LbnEPR0fGAblmzYKUrYJmCI0Wtks5s6ynLgaJpZM4QsUrm .