openrowingmonitor icon indicating copy to clipboard operation
openrowingmonitor copied to clipboard

Published 20 hours ago • verified publisher icon laberning

v1beta docs - C2 wiring

Open Abasz opened this issue 2 years ago • 4 comments

@JaapvanEkris are you sure that the wiring on the below picture is correct:

image

I mean shouldnt the signal connected to the positive and gnd to the negative terminal?

Abasz avatar Feb 11 '23 18:02 Abasz

It amazed me as well at the time, but it was the only way to make it work. I made pictures during my built, but I can't find them anymore. I'll look on my other laptop tomorrow, hope to find it there.

JaapvanEkris avatar Feb 12 '23 15:02 JaapvanEkris

That is very interesting. I have not taken measurements of the jack rings, but it might be (to the contrary on the picture) that the tip is gnd and the signal is on the sleev.

Abasz avatar Feb 12 '23 18:02 Abasz

Logically, it should indeed. I copied the info from this thread: https://www.c2forum.com/viewtopic.php?f=10&t=199082&p=532456#p532482 But I could have interpreted it wrong.

JaapvanEkris avatar Feb 12 '23 19:02 JaapvanEkris

I dont think this post says which is ground and which is signal. I suspect they are the other way around, but I may try to measure it with a multimeter next time I am at the gym (its already dodgy when I connect my level shifter any way :D)

Abasz avatar Feb 12 '23 21:02 Abasz