Kuba Szczodrzyński
Kuba Szczodrzyński
Then you didn't do what the guide says. This log output is NOT download mode, it's a normal boot. You need to connect TX2 to GND and then power on...
After that you need to disconnect CEN from ground, and then disconnect TX2 from ground. If you don't do this, it will never work. The instruction message includes these steps...
Hi We're more than open to any contributions. I haven't had much time to check your library repo yet, so I just gave it a quick look. Why do the...
We can accept such an approach (separate classes) as a temporary solution - until we cleanup the SDK and use the same versions of LwIP and mbedTLS on all platforms....
Your device most likely needs different encryption keys. OpenBeken currently doesn't have means to change encryption keys, LibreTiny/ESPHome does. But in order to find the encryption keys for your device,...
Yes, flashing a firmware with different keys will make it unable to boot. Depending on whether you've flashed OpenBeken using their official tool (which overwrites the bootloader) you might be...
Yes. With no parameters it should give a full 2 MiB firmware dump, which will most likely include the stock bootloader and your firmware flashing attempts.
This device uses default encryption keys - it's a Tuya device, they all use the same keys. Flashing ESPHome should work with no issues, using the default config. Make sure...
Sadly, no. You could try using an old version (before 4.8.0, I think) which had an old implementation of the RTL flashing tool.
Please post a full log with the error.