Dragonfly

Dragonfly copied to clipboard

provide qspi chip select signal for lower power consumption

5

i have a suggestion to reduce power consumption on the dragonfly, namely: use a chip select signal to the qspi flash. as it consumes more power when the chip select...

8bit-meiko

Can-Bus

1

I would like to use the canbus. Any ideas how to do that with the dragonfly? I think until now, there is no libary, is there anybody who have any...

PatKon90

dragonfly on usb host shield

1

I am trying to compile an Arduino usb hostshield code for the Dragonfly, and the compiler says ''please define board in avrpins.h''. How can i do this, i am on...

arpeggio1234

Correct a comment mistake according to the MPU9250 documentation for sampling frequency and sub-sampling configuration.

clemaitre58

MPU9250 Address strange

3

Hi Kris, I have the ladybug + MPU-9250 / BME280. I sold the 2 I2C pads and GND + VCC (no more) -->Is it great? I trried to run this...

clemaitre58

images

4


kriswiner

SPI CS pin name?

1

on the spi header, it is impossible to trace which pin the CS pin is without looking at the schematic. this can be a little problematic for newbies.

8bit-meiko