Add defined pullup for GPIO

[foogadgets]

There seem to be no pull-up or pull-down defined for the GPIO pin. Also added a defined flank trigger.

[ssorgatem]

Also, this repo is dead. The author is unresponsive. I've taken over as this plugin's maintainer. Check the new repo at: https://github.com/ssorgatem/Octoprint-Filament-Reloaded/tree/master

[foogadgets]

Great! Thanks for the notification.

I had problem with Filament Sensor Simplified because it resent the M600-code over and over again.

The Filament Sensor Reloaded looked nice with settings and UI-indicator, but it only sent M600 50% of the times I triggered it. My change to this “old” Filament Sensor Reloaded did not really work.

Third try was Filament Sensor NG and that actually worked well. No longer maintained, but one should not under estimate not touching something that works :)

I will try your version and see what I prefer.

Regards, Niclas

On 2 Nov 2020, at 16:30, Adrià Cereto Massagué [email protected] wrote:

Also, this repo is dead. The author is unresponsive. I've taken over as this plugin's maintainer. Check the new repo at: https://github.com/ssorgatem/Octoprint-Filament-Reloaded/tree/master https://github.com/ssorgatem/Octoprint-Filament-Reloaded/tree/master — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub https://github.com/kontakt/Octoprint-Filament-Reloaded/pull/59#issuecomment-720542939, or unsubscribe https://github.com/notifications/unsubscribe-auth/ACJHHW34AABXPZW3QKMMECLSN3GADANCNFSM4TGZHBJQ.

[ssorgatem]

Do open an issue if it's not working for you and we can try to fix it