Too many consecutive timeouts

[anakinjay]

Hello, I had a long print fail last night after the filament reloaded plugin kicked in.

The plugin did it's job, paused and ran the M600 command when the filament ran out. However, I guess it stopped responding to octopi while it was waiting for me to wake up and change the filament. In the morning I got this error:

Too many consecutive timeouts, printer still connected and alive?

The printer still responded to me changing the filament, but once it returned to where it could continue the print it just stopped because octopi was disconnected.

Any ideas what I did or setup wrong?

[kontakt]

Hmm, it sounds like after the M600 command, or just after a long time with no new commands the printer timed out. What firmware are you using?