Oliver Köster

I like the idea and your implementation looks very solid. Glad you followed the guidelines and added a new build environment. :) However, I see some minor problems here: 1....

Hi, To change the offset of the X-Carriage you can simply use the command M851. Just take a look at the instructions. It's described there (relatively far down). I can't...

I'll take a look at it. Thanks!

When I put my printer in a busy state, I get a message every 5 seconds. However, I have now changed a lot again and released a new 1.5.0 Beta...

Thanks for the extensive description! That helps me :) Could you do me a favor and tell me how many files are on the SD card? And would you do...

oh ok That is new. Previously, sorting the SD card used up too much RAM. Can you still test the 1.5.2?

No no, if you haven't used an SD card before, then you don't need to start now. It's important not to change too many variables at once.

So it doesn't look like a RAM issue. I'll investigate further. Would you mind testing the pre2 version? -> [MEGA_S_TMC_BLT_10_v1.5.2-pre2.hex.zip](https://github.com/knutwurst/Marlin-2-0-x-Anycubic-i3-MEGA-S/files/11859683/MEGA_S_TMC_BLT_10_v1.5.2-pre2.hex.zip)

@rafal1295 which firmware version did you use? 1.5.1. or 1.5.2? And can you test the current master branch? If the issue persists on the current master, I have to investigate...

Well, I'm happy to build a test version, but it would be useful if each of you could compile and test the current master. I'm still trying to figure out...