Oliver Köster

Hallo Oli, hier Olli :D Vielen Dank für die Doku! Ich werde dies bei Zeiten mit in die offizielle Doku übernehmen. Kurz dachte ich, du hättest einen Denkfehler, da ich...

> Das wird schätzungsweise an der kurzen Übersetzung im Extruder liegen. Richtig. Die weit verbreitete Annahme, dass der E0 Treiber eine deutlich höhere Vref benötigt wurde schon mehrfach widerlegt. Das...

Hi @Erik262 , sorry for answering so late but I had a lot to do :/ The current pull request cannot be merged because it would break all other anycubic...

Hi @harry7922 , Unfortunately, this is a known problem. Resume (by pause or filament runout) can only be executed via gcode via USB. The display implementation is flawed at this...

That looks very promising! Thanks a lot for this! My idea now was to move the pins on the board so that you don't have to switch off the Z-Endstops...

Hi, I'm sorry, but this is a known issue. See #344 and #350

Hi @elodur At the time I wrote the guide, there was no requirement for more memory. However, I have the current state + binary in my github, so it can...

The internal filament runout feature does not work atm, because the filament sensor is handled by the TFT display and its internal logic. Also you are using an old firmware...

Hi @PapeCoding , I didn't have the opportunity to further develop the firmware for some time. I'm looking into this, but to be honest this is a relatively low priority...

Fixed in https://github.com/knutwurst/Marlin-2-0-x-Anycubic-i3-MEGA-S/commit/62fcc2ff35c8cc17649e079fb2a2c70d77ae2b80 :) You can compile the current master, or wait for the final 1.5.0 release.