Oliver Köster

Hi @EasyG0ing1 , Thank you very much for your feedback! Yes, it looks like I should revise the guide again to make this clearer. I actually thought that point 7...

This doesn't read like a firmware issue. If the 4 point easy leveling works, then the coordinates can't be wrong either. Have you thought about loading and saving the defaults...

I am not sure if you are serious. Since you obviously know that you have an STM32 processor and also think that your bootloader is still there, I assume that...

32 bits is not equal to 32 bits. There is an (admittedly large) list of supported boards, but the Trigorilla Pro (that's what yours is called) isn't currently supported as...

Hi, so currently the laser only works with LightBurn via USB, but @stklcode is already working on implementing the laser functionality via the SD card to print BMP files. Unfortunately...

> and for use the laser with laightburn, i must do like stock method? i disconnect the hotend and connect the laser? That's correct. >just another question, is there a...

> please check 1920 beta But the 1920 does not have exFAT support...?

> It does. You're right! exfat and zso works fine in 1920!

Apologies for just now responding to this ticket. This is the same problem as described in ticket #350.

@wk2uboot Since this is a hybrid firmware, which is built for all Anycubic printers that are based on an Atmega256, this (known) error unfortunately also exists with every printer :(...