Marlin-2-0-x-Anycubic-i3-MEGA-S

Marlin-2-0-x-Anycubic-i3-MEGA-S copied to clipboard

firmware with laser engraving

22

djepsylon

So I hope this is the right place to place this because I'm not up to date with correct terminology (less than a year into 3d printing and coding) so...

TayBZ27

[BUG] 32bit AI3M Printer no longer booting after firmware 1.4.4 flash

4

### Bug Description I flashed my stock, previously untouched 32 bit Anycubic I3 Mega with the 1.4.4 firmware, specifically file MEGA_v1.4.4.hex as I was told in the beginner documentation. To...

HB-Stratos

[BUG] z2_min dauerhaft betätigt

1

### Bug Description Hallo, habe bei meinem Anycubic Mega Pro BLTouch nachgerüstet und die restlichen drei Treiber durch TMC2208 ersetzt. Danach habe ich die Firmware MEGA_P_DGUS_TMC_BLT_10_v1.4.4.hex installiert. Seitdem wird im...

iinovis

Trying to locate configuration for specific build

7

Hello, I've been using ```MEGA_X_DGUS_TMC_BLT_10_v1.4.4.hex``` and it's been working great. my new BLTouch works perfectly as does the replacement 2208 drivers. However, I would like to enable higher resolution where...

EasyG0ing1

Mesh Bed Leveling failed after FW update

3

Hello, everyone After the connector for the print head burned out, I took the chance to connected the BLTouch properly changing the wiring connection from 2-pin soldered to B5/6 to...

quantenquark

I created this BLTouch Calibration worksheet that you might want to add to the wiki. It goes into much more detail about what BLTouch calibration is, and I think it...

EasyG0ing1

### Description Activate fan kickstart to avoid hung fan on low rpm. At best it will be configurable together with Min/Max PWM without building the firmware. This would also make...

NilsRo

[BUG] "Print Completed" not poping up after print has finished

3

### Bug Description When a print is complete, a popup showing "Print Completed [time] ... [OK]" would come up. Some times it doesn't. The printer will be stuck in printing...

phenolplus

### Description This PR updates the upstream sources to [Marlin 2.1.2.1](https://github.com/MarlinFirmware/Marlin/tree/2.1.2.2) Diff [2.1.2.1...2.1.2.2](https://github.com/MarlinFirmware/Marlin/compare/2.1.2.1...2.1.2.2) #### Changes * Merged all upstream changes, hopefully preserving all patches Build tested for all targets. ###...

stklcode