Marlin-2-0-x-Anycubic-Kossel-Linear-Plus icon indicating copy to clipboard operation
Marlin-2-0-x-Anycubic-Kossel-Linear-Plus copied to clipboard

Published 20 hours ago • verified publisher icon knutwurst

Kossel Linear Plus

Open TobiasWeis opened this issue 4 years ago • 3 comments

Hi, the firmware for kossel linear plus seems to not be correct..

First issue: when probing, it will fail b/c the probe will not go all the way down. Only way to correct this was to set the z-height of the printer back to its original 300mm - why was that changed to 270 in your firmware anyway? Second: After measuring the probe-height and running the calibration, when I try to print with Cura (4.4), the extruder starts at what looks like a good height to me, then moves up into the air (about 1.5cm) above the printbead and tries to print the first layer there...

TobiasWeis avatar Oct 27 '20 21:10 TobiasWeis

Second problem was caused by cura 4.4 as it seems - with RepetierHost I can print as expected.

TobiasWeis avatar Oct 27 '20 21:10 TobiasWeis

Can confirm. After flashing, preset height was 270 and after changing it to 280mm (max value), z 0 was at 0.0 again.

ptc avatar Jan 09 '21 14:01 ptc

I can also confirm this. I had to change the delta height in:

Configuration → Delta Calibration → Delta Settings

to 280mm and store settings. After this, the auto calibration worked.

HenningTimm avatar May 08 '21 21:05 HenningTimm