kliment

@pedjas I think the core problem here is that your printer is configured to ignore reset commands from firmware. The off button stops sending commands and turns off heaters and...

My opinion on this: There are two situations in which M114 is better - when the device has rebooted and has lost its state (and therefore its last requested position...

That said, you can already add a custom button to send M114, and this might be a good interim solution.

The only time they mismatch is when you connect to a machine without resetting on connect, and the machine is in a particular state but we don't know it and...

@volconst thanks, you're awesome!

It is not. See #1159 - it's a false positive

Please use the "report as false positive" option if you can. It's being detected because it has a python interpreter in it, which several forms of malware also do.

Apparently the same thing happens quite regularly - [here](https://steamcommunity.com/app/379210/discussions/0/353915953245690255/)'s an example of one, [here](https://community.adobe.com/t5/download-install/virus-in-installation-file/td-p/9369736) is another

I think the issue is that that guide is for an older version of pronterface, which used python2. The current dependencies all use python3. You should check if printrun is...

This is probably a hardware problem - I suspect you have a power brownout on your board because your new hotend pulls too much power, and it's causing the microcontroller...