home-assistant-glow

home-assistant-glow copied to clipboard

Add filters for reducing amount of data output

5

This change adds commented-out samples of how to use filters to reduce the amount of data that are written to the HA recorder database by default. Depending on the `pulse_rate`...

slovdahl

Filtering out extreme values

43

I seem to be getting some noise on my sensor and I get very extreme values when this happens. These readings are usually over 100,000 W up to over 1...

mark-10-5

Calculating Remaining Units

5

I love this integration. Got it working quite well with an LDR since I don't have access to photodiode. I have a prepaid meter where I load e.g 500 units...

jacauc

No pulse detected

21

Hello! I get not pulse detected even though I have put the diode in front of the red blinking led on the power meter. Perhaps I should try change the...

olskar

Values reported by Glow much higher

26

Hi All, I've recently setup the glow on my electricity meter and all seemed to be working well. However, I have noticed that the power consumption readings are going up...

Joeboyc2

Documentation clarification

5

I had HUGE problems with flashing my board until I removed all dupont wires before flashing... I think the order of your tutorial might be problematic. Further it would be...

wormiedk

Strange values from the pulse_meter

8

I can't figure out what I'm doing wrong. The pulse_meter does not count pulses (W) and the total energy increase for each pulse is much higher than expected. Here is...

adorobis

How to calculate price as per the units consumed

2

Hi , this is great and thank you for wonderful project. as i saw in HA their is option to calculate static price per kWH consumed. but here in my...

itsboo07

Measurement on bi-directional meter (Germany/Zweirichtungszähler)

3

Hello My house has a bi-directional meter with an IR-Signal (10.000 imp./kWh) which works fine with the sensor in general BUT: As this is recording exported and imported energy the...

klaus1956

Active/Reactive power measurements

2

Hi, I'm not sure this is the right place for this question, so if it's not, please feel free to close this issue/point me elsewhere. TL-DR: I'm know very little...

phrfpeixoto