Mkrwifi1010

[KjellMorgenstern]

Adding support for Arduino Nano and MKR WIFI 1010. The later was tested with an FDM printer.

This introduces:

• Variable hole sizes, since the later boards have smaller mounting holes
• Dual headers (HEADER_F on top, HEADER_M on the bottom) as used on the MKR WIFI 1010
• Small pin (=NOTCH) that can be FDM printed, to fit the small holes from Nano and MKR boards
• Spacing parameter for enclosures, so that boards that need more than 5mm can fit.

[KjellMorgenstern]

Bump

[jones139]

Thanks for adding the Nano - I just found this library and was going to add support for the Nano, but I see you have done it. I'll try it out later.